Discard Compressor Outlet Filter-Element
TASK 38-42-00-610-001-A
Discard Compressor Outlet Filter-Element
Refer to the MPD TASK: 384242-01
DISCARD COMPRESSOR OUTLET FILTER ELEMENT.
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Consumable Materials
C. Work Zones and Access Panels
D. Expendable Parts
E. Referenced Information
3. Job Set-up
Subtask 38-42-00-861-051-A ** ON A/C NOT FOR ALL Subtask 38-42-00-614-050-A ** ON A/C NOT FOR ALL Subtask 38-42-00-865-051-A ** ON A/C NOT FOR ALL
Subtask 38-42-00-020-052-B ** ON A/C NOT FOR ALL
Subtask 38-42-00-410-051-D ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.04.02 06:26:01 UTC
Discard Compressor Outlet Filter-Element
WARNING:
MAKE SURE THAT THE PNEUMATIC SYSTEM IS DEPRESSURIZED BEFORE YOU START WORK. PRESSURIZED AIR CAN CAUSE INJURY TO PERSONNEL.
WARNING:
BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.
1. Reason for the JobRefer to the MPD TASK: 384242-01
DISCARD COMPRESSOR OUTLET FILTER ELEMENT.
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | 1 | ACCESS PLATFORM 2M (6 FT) |
| No specific | Torque wrench: range to between 1.1 and 0.99 m.daN (97.35 and 87.61 lbf.in ) ![]() |
| REFERENCE | DESIGNATION |
|---|---|
| (Material No.08BBC1) | Non Aqueous Cleaner-- Naphta based and Alcohol - |
| (Material No.14SBA1) | Textile-Lint free Cotton - |
| No specific | corrosion-resistant steel lockwire 0.8 mm (0.032 in) dia |
| ZONE/ACCESS | ZONE DESCRIPTION |
|---|---|
| 137 | BAY BETW AFT PART. BULKHEAD OF FWD CARGO |
| 163 | U/FLOOR BAY OF BULK CARGO COMPARTMENT |
| 171 | AFT CABIN U/FLOOR COMPARTMENT |
| 161DW |
| FIG.ITEM | DESIGNATION | IPC-CSN |
|---|---|---|
| 5 | O-RING | AIPC 38-42-42-01-020 |
| 4 | O-RING | AIPC 38-42-42-01-030 |
| 3 | CARTRIDGE | AIPC 38-42-42-01-040 |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 24-42-00-861-001-A | Energize the Ground Service Network from the External Power |
| TASK 24-42-00-862-001-A | De-energize the Ground Service Network Supplied from the External Power |
| TASK 25-55-12-000-001-A | Removal of the Aft Cargo-Compartment Partition at FR65 |
| TASK 25-55-12-400-001-A | Installation of the Aft Cargo-Compartment Partition at FR65 |
| TASK 38-10-00-614-002-A | Depressurization of the Potable Water System |
| TASK 38-42-00-710-001-A | Operational Test of the Auxiliary Air Supply System. |
| TASK 52-30-00-860-001-A | Open the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump |
| TASK 52-30-00-860-002-A | Close the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump |
| TASK 52-30-00-860-003-A | Open the FWD or Aft Cargo-Compartment Door with the Hand Pump |
| TASK 52-30-00-860-004-A | Close the FWD or Aft Cargo-Compartment Door with the Hand Pump |
Subtask 38-42-00-861-051-A ** ON A/C NOT FOR ALL Subtask 38-42-00-614-050-A ** ON A/C NOT FOR ALL Subtask 38-42-00-865-051-A ** ON A/C NOT FOR ALL
C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged:
Subtask 38-42-00-010-051-D ** ON A/C NOT FOR ALL | PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 2001VU | WATER SYS-AIR-COMPRESSOR | 19MD | F01 |
D. Get Access
(1) Open the aft cargo-compartment door (Ref. AMM TASK 52-30-00-860-001) or (Ref. AMM TASK 52-30-00-860-003).
(2) Put an ACCESS PLATFORM 2M (6 FT) in position at the aft cargo-compartment door.
(3) Set cargo-compartment light switch 8LU to ON position.
(4) Remove access panel 161DW (Ref. AMM TASK 25-55-12-000-001).
4. Procedure(1) Open the aft cargo-compartment door (Ref. AMM TASK 52-30-00-860-001) or (Ref. AMM TASK 52-30-00-860-003).
(2) Put an ACCESS PLATFORM 2M (6 FT) in position at the aft cargo-compartment door.
(3) Set cargo-compartment light switch 8LU to ON position.
(4) Remove access panel 161DW (Ref. AMM TASK 25-55-12-000-001).
Subtask 38-42-00-020-052-B ** ON A/C NOT FOR ALL
A. Removal of the Cartridge Air Filter 4212MM
(1) Disconnect the tube (1).
(2) Cut and remove the lockwire from the cap (2).
(3) Remove the cap (2).
(4) Remove and discard the cartridge (3).
(5) Remove and discard the O-rings (4) and (5).
Subtask 38-42-00-110-050-A ** ON A/C NOT FOR ALL (1) Disconnect the tube (1).
(2) Cut and remove the lockwire from the cap (2).
(3) Remove the cap (2).
(4) Remove and discard the cartridge (3).
(5) Remove and discard the O-rings (4) and (5).
B. Make sure that the parts retained from the removed component are clean and in the correct condition.
(1) Clean all metal parts with Non Aqueous Cleaner-- Naphta based and Alcohol - (Material No.08BBC1) and a Textile-Lint free Cotton - (Material No.14SBA1) .
Subtask 38-42-00-420-052-B ** ON A/C NOT FOR ALL (1) Clean all metal parts with Non Aqueous Cleaner-- Naphta based and Alcohol - (Material No.08BBC1) and a Textile-Lint free Cotton - (Material No.14SBA1) .
C. Installation of the Cartridge Air Filter 4212MM
(1) Put a new AIPC 38-42-42-01-020 O-RING (5) into the filter housing (6).
(2) Put a new AIPC 38-42-42-01-030 O-RING (4) onto the new AIPC 38-42-42-01-040 CARTRIDGE (3).
(3) Install the cartridge (3).
(4) Install the cap (2).
(5) Safety the cap (2) with corrosion-resistant steel lockwire 0.8 mm (0.032 in) dia.
(6) Connect the tube (1).
(7) TORQUE the nut of the tube (1) to between 1.1 and 0.99 m.daN (97.35 and 87.61 lbf.in )
.
Subtask 38-42-00-865-054-A ** ON A/C NOT FOR ALL (1) Put a new AIPC 38-42-42-01-020 O-RING (5) into the filter housing (6).
(2) Put a new AIPC 38-42-42-01-030 O-RING (4) onto the new AIPC 38-42-42-01-040 CARTRIDGE (3).
(3) Install the cartridge (3).
(4) Install the cap (2).
(5) Safety the cap (2) with corrosion-resistant steel lockwire 0.8 mm (0.032 in) dia.
(6) Connect the tube (1).
(7) TORQUE the nut of the tube (1) to between 1.1 and 0.99 m.daN (97.35 and 87.61 lbf.in )
. D. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):
Subtask 38-42-00-710-051-A ** ON A/C NOT FOR ALL | PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 2001VU | WATER SYS-AIR-COMPRESSOR | 19MD | F01 |
E. Operational Test
(1) Do an operational test of the auxiliary air-supply system (Ref. AMM TASK 38-42-00-710-001)
(2) Examine air filter 4212MM for leaks.
5. Close-up(1) Do an operational test of the auxiliary air-supply system (Ref. AMM TASK 38-42-00-710-001)
(2) Examine air filter 4212MM for leaks.
NOTE: Leaks are not permitted.
Subtask 38-42-00-410-051-D ** ON A/C NOT FOR ALL
A. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Install access panel 161DW (Ref. AMM TASK 25-55-12-400-001).
(3) Set cargo-compartment light switch 8LU to OFF position.
(4) Remove the access platform(s).
(5) Close the aft cargo-compartment door (Ref. AMM TASK 52-30-00-860-002) or (Ref. AMM TASK 52-30-00-860-004).
(6) Remove the ground support and maintenance equipment, the special and standard tools and all other items.
Subtask 38-42-00-862-051-A ** ON A/C NOT FOR ALL (1) Make sure that the work area is clean and clear of tools and other items.
(2) Install access panel 161DW (Ref. AMM TASK 25-55-12-400-001).
(3) Set cargo-compartment light switch 8LU to OFF position.
(4) Remove the access platform(s).
(5) Close the aft cargo-compartment door (Ref. AMM TASK 52-30-00-860-002) or (Ref. AMM TASK 52-30-00-860-004).
(6) Remove the ground support and maintenance equipment, the special and standard tools and all other items.
Air Filter 4212MM