Installation of the Check Valve

TASK 38-31-65-400-001-A
Installation of the Check Valve

WARNING: DO NOT DO WORK ON THE TOILET WASTE SYSTEM AND THE POTABLE WATER SYSTEM AT THE SAME TIME. THIS WILL PREVENT CONTAMINATION OF THE POTABLE WATER SYSTEM. SUCH CONTAMINATION CAN BE DANGEROUS TO HEALTH.

WARNING: ALWAYS USE RUBBER GLOVES WHEN YOU DO WORK:

ON THE TOILET WASTE SYSTEM, OR
ON PARTS THAT HAVE CONTAMINATION FROM THE WASTE SYSTEM.

WHEN YOU COMPLETE THE WORK PROCEDURE, CLEAN YOUR HANDS WITH SOAP AND WATER. THIS WILL PREVENT INFECTION (TOILET WASTE IS DANGEROUS FOR HEALTH).

FIN: 3320MM

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
161DW, 162DW

B. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 24-41-00-862-002-A	De-energize the Aircraft Electrical Circuits Supplied from the External Power
TASK 24-41-00-862-002-A-01	De-energize the Aircraft Electrical Circuits Supplied from the APU
TASK 24-41-00-862-002-A-02	De-energize the Aircraft Electrical Circuits Supplied from the Engine 1(2)
TASK 38-31-00-710-009-A	Operational Test of the Toilet Unit
TASK 52-30-00-860-002-A	Close the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump
Check Valve ** ON A/C NOT FOR ALL
Check Valve ** ON A/C NOT FOR ALL

3. Job Set-up
Subtask 38-31-65-860-050-A

A. Aircraft Maintenance Configuration
(1) Make sure that the aircraft electrical circuits are energized (Ref. AMM TASK 24-41-00-861-002).

Subtask 38-31-65-865-060-A

B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged:

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-VACUUM-SYS	35MG	A06
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-VACUUM-GEN	33MG	A08
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-E	34MG	A04
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-D	39MG	A03
** ON A/C ALL
2001VU	VACU TOIL SYS-LAV PWR-A	32MG	A01
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-VACU-SYS	35MG	A06
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-VACU-GEN	33MG	A08
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-G	34MG	A04
2001VU	VACU TOIL SYS-LAV PWR-F	39MG	A03
2001VU	VACU TOIL SYS-LAV PWR-D	45MG	A02
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-L	45MG	A02
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-L	23MG	A05
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-M	34MG	A04

4. Procedure
Subtask 38-31-65-420-050-A

A. Installation of the Check Valve 33200MM
(1) Remove the blanking plugs from the line ends.
(2) Put the check valve 3320 MM in position.

NOTE: Make sure that the check valve is installed in the correct direction of flow.

(3) Install the sleeves (2).
(4) Install the clamps (1).

Subtask 38-31-65-865-062-A

B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-VACUUM-SYS	35MG	A06
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-VACUUM-GEN	33MG	A08
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-E	34MG	A04
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-D	39MG	A03
** ON A/C ALL
2001VU	VACU TOIL SYS-LAV PWR-A	32MG	A01
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-VACU-SYS	35MG	A06
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-VACU-GEN	33MG	A08
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-G	34MG	A04
2001VU	VACU TOIL SYS-LAV PWR-F	39MG	A03
2001VU	VACU TOIL SYS-LAV PWR-D	45MG	A02
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-L	45MG	A02
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-L	23MG	A05
** ON A/C NOT FOR ALL
2001VU	VACU TOIL SYS-LAV PWR-M	34MG	A04

Subtask 38-31-65-710-050-A

C. Operate the toilet and make sure that it flushes correctly (Ref. AMM TASK 38-31-00-710-009).

5. Close-up
Subtask 38-31-65-410-050-A

A. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Install the access panel 161DW and 162DW.
(3) Close the AFT cargo compartment door (Ref. AMM TASK 52-30-00-860-002).
(4) Remove the access platform(s).

Subtask 38-31-65-862-050-A

B. De-energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-862-002).

[Rev.10 from 2021] 2026.04.01 01:20:49 UTC