Removal of the Control Cable

TASK 38-14-49-000-004-A
Removal of the Control Cable

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	ACCESS PLATFORM 1M(3 FT)
No specific	AR	ACCESS PLATFORM 2M (6 FT)
No specific	AR	ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE
No specific	AR	ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
131EF, 131FF, 131GF, 131HW, 133AL, 171AL, 825, 832, 842

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 38-10-00-614-002-A	Depressurization of the Potable Water System
TASK 52-10-00-010-001-A	Opening of the Passenger/Crew Door
TASK 52-30-00-860-001-A	Open the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump
TASK 52-30-00-860-003-A	Open the FWD or Aft Cargo-Compartment Door with the Hand Pump
Control Cable

3. Job Set-up
Subtask 38-14-49-861-051-A

A. Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).

Subtask 38-14-49-680-059-A

B. Depressurize the potable water system (Ref. AMM TASK 38-10-00-614-002).

Subtask 38-14-49-010-053-A

C. Get Access
(1) Put an ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE in position in front of the applicable passenger/crew door 832 or 842.
(2) Open passenger/crew door 832 or 842 (Ref. AMM TASK 52-10-00-010-001).
(3) Put an ACCESS PLATFORM 1M(3 FT) in position at drain panel 133AL.
(4) Open drain panel 133AL.
(5) In the drain panel, put WARNING NOTICE(S) to tell persons not to turn the control handle.
(6) Put an ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position at service panel 2023VU.
(7) Open access door 171AL of service panel 2023VU.
(8) In service panel 2023VU put the WARNING NOTICE(S) to tell persons not to turn the control handle.
(9) Put an ACCESS PLATFORM 2M (6 FT) in position at forward cargo-compartment door 825.
(10) Open forward cargo-compartment door 825 (Ref. AMM TASK 52-30-00-860-001) (Ref. AMM TASK 52-30-00-860-003).
(11) Set cargo-compartment light switch 6LU to ON.
(12) In the forward cargo-compartment, remove sidewall panel 131HW and floor panels 131EF 131FF 131GF.

Subtask 38-14-49-865-053-A

D. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
124VU	SVCE/601PP/602PP/SPLY	1PX	BB01

4. Procedure
Subtask 38-14-49-020-051-A

A. Remove the Control Cable

NOTE: If necessary remove the insulation sleeve.

(1) Remove the nuts (1), the washers (2) and the clamps (3).
(2) Cut the tie-down strap (17) (see detail D).
(3) Disconnect the lead-bonding
(a) Remove the nut (18), the washer (19) and disconnect the lead-bonding (20) (see detail C).
(4) At the clevis (11):
(a) Remove and discard the cotter pin (4), and remove the washer (5).
(b) Remove the pin (6) from the clevis (11).
(c) Remove and discard the lockwire at the locknut (10).
(d) Remove the clevis (11) and the locknut (10) from the cable (9).
(5) At the sliding end (8):
(a) Remove and discard the cotter pin (4), and remove the washer (5).
(b) Remove the pin (6) from the sliding end (8).
(c) Loosen the self-locking nut (7) but do not remove it.
(d) Turn the sliding end (8) clockwise and remove it from the cable (9).
(6) Pull the cable (9) cut of the rigid sleeve (15) and the swivel ends (12).
(7) Loosen the hollow hex head screws (16) at the swivel ends (12) and remove the rigid sleeve (15).
(8) Remove the nuts (14), the washers (13) and the swivel ends (12).

[Rev.10 from 2021] 2026.04.02 06:25:45 UTC