Removal of the Control Cable

TASK 38-14-48-000-001-A
Removal of the Control Cable

FIN: 3260MM ** ON A/C NOT FOR ALL
FIN: 3261MM ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 1M(3 FT)
No specific	1	ACCESS PLATFORM 2M (6 FT)
No specific	1	ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE
No specific	AR	ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
132PW, 171AL, 192NB, 825, 832, 842

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 38-10-00-614-002-A	Depressurization of the Potable Water System
TASK 52-10-00-010-001-A	Opening of the Passenger/Crew Door
TASK 52-30-00-860-001-A	Open the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump
Control Cable - Component Location (3260MM, 3261MM)
Control Cable 3260MM
Control Cable 3261MM

3. Job Set-up
Subtask 38-14-48-861-052-A ** ON A/C NOT FOR ALL

A. Energize the ground service network (Ref. AMM TASK 24-42-00-861-001).

Subtask 38-14-48-010-058-A ** ON A/C NOT FOR ALL

B. Get Access
(1) Put an ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE in position in front of the applicable passenger/crew door 832 or 842.
(2) Open the passenger/crew door 832 or 842 (Ref. AMM TASK 52-10-00-010-001).

Subtask 38-14-48-680-050-A ** ON A/C NOT FOR ALL

C. Depressurize the potable water system (Ref. AMM TASK 38-10-00-614-002).

Subtask 38-14-48-010-056-A ** ON A/C NOT FOR ALL

D. Get Access
(1) Put an ACCESS PLATFORM 1M(3 FT) in position at the drain and overflow panel 192NB.
(2) Open the drain and overflow panel 192NB.
(3) In the drain and overflow panel, put the WARNING NOTICE(S) to tell persons not to turn the control handle.
(4) Put an ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE in position at the service panel 2023VU.
(5) Open the access door 171AL of the service panel 2023VU.
(6) In the service panel 2023VU, put the WARNING NOTICE(S) to tell persons not to turn the control handle.
(7) Put an ACCESS PLATFORM 2M (6 FT) in position at the FWD cargo-compartment door 825
(8) Open the FWD cargo-compartment door 825 (Ref. AMM TASK 52-30-00-860-001).
(9) Set the CARGO COMPT LIGHT switch 6LU to ON.
(10) In the FWD cargo-compartment, remove the partition panel 132PW.

Subtask 38-14-48-865-050-A ** ON A/C NOT FOR ALL

E. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
124VU	SVCE/601PP/602PP/SPLY	1PX	BB01

4. Procedure
Subtask 38-14-48-020-050-A ** ON A/C NOT FOR ALL

WARNING: USE PROTECTIVE GOGGLES AND GLOVES WHEN YOU REMOVE OR INSTALL LOCKWIRE. EACH TIME YOU CUT LOCKWIRE, REMOVE AND DISCARD IT IMMEDIATELY. LOOSE LOCKWIRE CAN CUT YOU OR MAKE YOU BLIND, AND/OR CAN CAUSE DAMAGE.

A. Removal of the Control Cable

NOTE: If necessary remove the insulation sleeve.

(1) At the clevis (12):
(a) Remove and discard the cotter pin (1), and remove the washer (2).
(b) Remove the pin (3) from the clevis (12).
(c) If there is a lockwire at the locknut (13), remove and discard it.
(d) Remove the clevis (12) and the locknut (13) from the cable (9).
(2) At the sliding end (5):
(a) Remove and discard the cotter pin (1), and remove the washer (2).
(b) Remove the pin (3) from the sliding end (5).
(c) Loosen the self-locking nut (4) but do not remove it.
(d) Turn the sliding end (5) clockwise and remove it from the cable (9).
(e) Pull the cable (9) out of the rigid sleeve (10) and the swivel ends (6).
(3) Loosen the hollow hex head screws (11) at the swivel ends (6) and remove the rigid sleeve (10).
(4) Remove the nuts (8), the washers (7) and the swivel ends (6).

[Rev.10 from 2021] 2026.04.02 06:25:45 UTC