Removal of the Electronic Control Box
TASK 38-12-41-000-005-A
Removal of the Electronic Control Box
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Referenced Information
3. Job Set-up
Subtask 38-12-41-861-053-A ** ON A/C NOT FOR ALL Subtask 38-12-41-010-057-A ** ON A/C NOT FOR ALL
Subtask 38-12-41-020-054-A ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.04.02 06:25:40 UTC
Removal of the Electronic Control Box
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | AR | CAP - BLANKING |
| No specific | AR | SAFETY CLIP - CIRCUIT BREAKER |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 24-42-00-861-001-A | Energize the Ground Service Network from the External Power |
| TASK 38-10-00-614-002-A | Depressurization of the Potable Water System |
Subtask 38-12-41-861-053-A ** ON A/C NOT FOR ALL Subtask 38-12-41-010-057-A ** ON A/C NOT FOR ALL
B. Get Access to the Lavatory
(1) Open the door of the sanitary cabinet.
Subtask 38-12-41-865-054-A ** ON A/C NOT FOR ALL (1) Open the door of the sanitary cabinet.
C. Open, safety and tag this(these) circuit breaker(s):
Subtask 38-12-41-860-057-A ** ON A/C NOT FOR ALL | PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 2001VU | VACU TOIL SYS-LAV PWR-M | 34MG | A04 |
| 2001VU | VACU TOIL SYS-LAV PWR-D | 39MG | A03 |
| 2001VU | VACU TOIL SYS-LAV PWR-L | 45MG | A02 |
| 2001VU | VACU TOIL SYS-LAV PWR-A | 32MG | A01 |
D. Aircraft Maintenance Configuration
(1) Depressurize the potable water system (Ref. AMM TASK 38-10-00-614-002)
4. Procedure(1) Depressurize the potable water system (Ref. AMM TASK 38-10-00-614-002)
Subtask 38-12-41-020-054-A ** ON A/C NOT FOR ALL
A. Removal of the Electronic Control Box
(1) Disconnect the connectors (4), (5), (6) and (7) from the electronic box (1).
(2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Remove the screws (3) and the washers (2).
(4) Remove the electronic box (1).
(1) Disconnect the connectors (4), (5), (6) and (7) from the electronic box (1).
(2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Remove the screws (3) and the washers (2).
(4) Remove the electronic box (1).
Electronic Control Box