Removal of the HP Ground Connector

TASK 36-13-41-000-001-A
Removal of the HP Ground Connector

WARNING: MAKE SURE THAT THE PNEUMATIC SYSTEM IS DEPRESSURIZED BEFORE YOU START WORK. PRESSURIZED AIR CAN CAUSE INJURY TO PERSONNEL.

FIN: 7300HM

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE
No specific	1	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	2	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
191BB

C. Referenced Information

REFERENCE	DESIGNATION
HP Ground Connector 7300HM ** ON A/C NOT FOR ALL
HP Ground Connector 7300HM ** ON A/C NOT FOR ALL

3. Job Set-up
Subtask 36-13-41-865-050-A

A. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	AIR BLEED/ENG 1/CTL	3HA1	D12
49VU	AIR BLEED/ENG 1/MONG	2HA1	D11
** ON A/C ALL
49VU	AIR BLEED/X FEED/VALVE/BAT	2HV	D13
** ON A/C NOT FOR ALL
49VU	AIR BLEED/ENG 2/MONG	3HA2	D12
49VU	AIR BLEED/ENG 1/CTL	2HA1	D11
** ON A/C NOT FOR ALL
122VU	AIR BLEED/ENG 2/CTL	3HA2	Z23
122VU	AIR BLEED/ENG 2/MONG	2HA2	Z22
** ON A/C ALL
122VU	AIR BLEED/X FEED VALVE/NORM	1HV	Z20
** ON A/C NOT FOR ALL
122VU	AIR BLEED/ENG 1/MONG	3HA1	Z23
122VU	AIR BLEED/ENG 2/CTL	2HA2	Z22

Subtask 36-13-41-860-050-A

B. Aircraft Maintenance Configuration
(1) Put the WARNING NOTICE(S) in position:

in the cockpit on the Engine Control Panel 115VU to tell persons not to start the engine(s),
in the cockpit on the AIR COND Overhead Control Panel 30VU to tell persons not to push in the APU BLEED pushbutton switch.

(2) Put the ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position below access panel 191BB.

Subtask 36-13-41-010-050-A

C. Remove the access panel 191BB.

4. Procedure
Subtask 36-13-41-020-050-A

A. Removal of the HP Ground Connector
(1) Hold the HP Ground Connector (3) and remove the nuts (1) with the washers (2) from the duct.
(2) Discard the nuts (1).
(3) Remove the HP Ground Connector (3) and the sealing ring (6) from the duct.
(4) Remove the check valve (5) and the O-ring (4) from the HP Ground Connector (3).
(5) Put the CAP - BLANKING in the open end of the duct.

[Rev.10 from 2021] 2026.04.01 01:16:06 UTC