Removal of the Accent Mirror Light

TASK 33-24-12-000-804-A
Removal of the Accent Mirror Light

FIN: 62LQ111 ** ON A/C NOT FOR ALL
FIN: 62LQ112 ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ELEC CONTACTS INSERTION EXTRACTION TOOL M15570-20
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER

B. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 33-24-12-000-803-A	Removal of the Accent Ceiling Light
TASK 33-24-12-000-805-A	Removal of the Accent Washtable Light
Accent Mirror Light

3. Job Set-up
Subtask 33-24-12-860-057-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).

Subtask 33-24-12-865-064-A ** ON A/C NOT FOR ALL

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	LIGHTING/EMER LT/CABIN	79WL	H07
** ON A/C NOT FOR ALL
49VU	LIGHTING/EMER LT/CABIN	79WL	H05
** ON A/C NOT FOR ALL
2000VU	LAV FWD-OCCUPIED	1WJ	F01
** ON A/C NOT FOR ALL
2000VU	LIGHT-LAV	1LQ	J01
** ON A/C NOT FOR ALL
2000VU	LAV FWD & MID-OCCUPIED	1WJ	F01
** ON A/C NOT FOR ALL
2001VU	LAVATORY AFT-OCCUPIED	11WJ	B04

Subtask 33-24-12-010-053-A ** ON A/C NOT FOR ALL

C. Get Access

Accent Mirror Light ** ON A/C NOT FOR ALL

(1) Get Access to the Accent Mirror Light in the SMART lavatory:
(a) FOR 62LQ*
1 On the upper service panel (7), loosen the two studs (8) to open and lower the service panel (7).
2 On the service cabinet above the baby nursing table, in the upper left and right corner, push the service cabinet to disengage and open it.
3 Remove the cover of the ceiling light (Ref. AMM TASK 33-24-12-000-803).
4 Remove the cover of the washtable light (Ref. AMM TASK 33-24-12-000-805).

4. Procedure
Subtask 33-24-12-020-054-A ** ON A/C NOT FOR ALL

A. Removal of the Accent Mirror Light

Accent Mirror Light ** ON A/C NOT FOR ALL

(1) Remove the screws (9), the washers (10) and remove the brackets (12) with the terminal block (6) from the lavatory wall.

CAUTION: MAKE SURE THAT THE ELECTRICAL CONNECTORS ARE CLEAN BEFORE YOU DISCONNECT OR CONNECT THEM. CONTAMINATION ON THE ELECTRICAL CONNECTORS CAN CAUSE DAMAGE TO EQUIPMENT.

CAUTION: MAKE MATCH MARKS ON ALL THE ELECTRICAL WIRES BEFORE YOU DISCONNECT THEM. INCORRECT CONNECTION OF WIRES WILL CAUSE DAMAGE TO EQUIPMENT.

(2) Disconnect the electrical contacts (1) from the terminal block (6), use the ELEC CONTACTS INSERTION EXTRACTION TOOL M15570-20.
(3) Cut and discard the TIE WRAPS (5) to release the cable (11).
(4) Carefully pull the mirror light cover (3) on the top and bottom edge to disengage and remove it.
(5) Pull the accent mirror light (2) to release it from the clamps (4).
(6) Remove the accent mirror light (2).

[Rev.10 from 2021] 2026.04.01 00:53:41 UTC