Removal of the Alternate-Brake Servovalve Manifold Filter
TASK 32-43-31-000-002-A
Removal of the Alternate-Brake Servovalve Manifold Filter
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Referenced Information
3. Job Set-up
Subtask 32-43-31-941-053-A ** ON A/C NOT FOR ALL
Subtask 32-43-31-020-051-B ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.04.01 00:49:08 UTC
Removal of the Alternate-Brake Servovalve Manifold Filter
WARNING:
PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
- THE FLIGHT CONTROLS
- THE FLIGHT CONTROL SURFACES
- THE LANDING GEAR AND THE RELATED DOORS
- COMPONENTS THAT MOVE.
WARNING:
MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.
1. Reason for the JobSelf explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | 1 | ACCESS PLATFORM 3M (10 FT) |
| No specific | 1 | CONTAINER 5 L (1.32 USGAL) |
| No specific | AR | SAFETY BARRIER(S) |
| No specific | AR | SAFETY CLIP - CIRCUIT BREAKER |
| No specific | AR | WARNING NOTICE(S) |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 29-00-00-864-001-A | Put the Related Hydraulic System in the Depressurized Configuration before Maintenance Action |
| TASK 29-23-00-860-001-A | Disconnection of the Isolation Coupling of the Power Transfer Unit (PTU) |
| TASK 32-00-00-481-001-A | Installation of the Safety Devices on the Landing Gears |
Subtask 32-43-31-941-053-A ** ON A/C NOT FOR ALL
A. Safety Precautions
(1) Put the SAFETY BARRIER(S) in position.
(2) Make sure that the ground safety locks are installed on the landing gear (Ref. AMM TASK 32-00-00-481-001).
(3) On the panel 400VU:
Subtask 32-43-31-860-053-A ** ON A/C NOT FOR ALL (1) Put the SAFETY BARRIER(S) in position.
(2) Make sure that the ground safety locks are installed on the landing gear (Ref. AMM TASK 32-00-00-481-001).
(3) On the panel 400VU:
- make sure that the landing-gear control-lever 6GA is in the DOWN position
- put a WARNING NOTICE(S) in position to tell persons not to operate the landing gear.
B. Aircraft Maintenance Configuration
(1) Make sure that the Yellow hydraulic system has been depressurized (Ref. AMM TASK 29-00-00-864-001).
(2) Operate the brake pedals until the pressure in the brake accumulator of the Yellow hydraulic system is at zero.
(3) Put an ACCESS PLATFORM 3M (10 FT) below the applicable false rear spar at the alternate-brake servovalve manifold.
(4) Put a CONTAINER 5 L (1.32 USGAL) below the manifold.
(5) Disconnect the isolation coupling of the Power Transfer Unit (PTU) (Ref. AMM TASK 29-23-00-860-001).
Subtask 32-43-31-865-053-A ** ON A/C NOT FOR ALL (1) Make sure that the Yellow hydraulic system has been depressurized (Ref. AMM TASK 29-00-00-864-001).
(2) Operate the brake pedals until the pressure in the brake accumulator of the Yellow hydraulic system is at zero.
(3) Put an ACCESS PLATFORM 3M (10 FT) below the applicable false rear spar at the alternate-brake servovalve manifold.
(4) Put a CONTAINER 5 L (1.32 USGAL) below the manifold.
(5) Disconnect the isolation coupling of the Power Transfer Unit (PTU) (Ref. AMM TASK 29-23-00-860-001).
C. Open, safety and tag this(these) circuit breaker(s):
4. Procedure| PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 121VU | HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY | 4GG | M36 |
| 121VU | HYDRAULIC/BRAKING AND STEERING/SYS2/CTL | 3GG | M35 |
| 121VU | HYDRAULIC/BRAKING AND STEERING/SYS1/CTL | 1GG | M34 |
| 121VU | HYDRAULIC/BRAKING AND STEERING/SYS1/IND AND/SPLY | 2GG | M33 |
| 121VU | HYDRAULIC/PARK BRK/CTL/STBY | 71GG | N37 |
| 121VU | HYDRAULIC/PARK BRK/CTL/NORM | 70GG | N36 |
| 121VU | HYDRAULIC/HYD POWER/Y | 3803GX | N30 |
| 123VU | Y HYD/ELEC/PUMP | 3802GX | AB06 |
| 123VU | Y HYD/ELEC/ELEC PUMP/NORM | 3801GX | AB03 |
Subtask 32-43-31-020-051-B ** ON A/C NOT FOR ALL
A. Removal of the Alternate-Brake Servovalve Manifold Filter
(2) Remove and discard the retainer (2) and the packing (3) from the plug (1).
(3) Carefully remove and discard the filter (4) and the packing (5) from the manifold.
WARNING:
DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU DO:
- FLUSH IT AWAY WITH CLEAN WATER
- GET MEDICAL AID.
WARNING:
USE PROTECTIVE GOGGLES AND GLOVES WHEN YOU REMOVE OR INSTALL LOCKWIRE. EACH TIME YOU CUT LOCKWIRE, REMOVE AND DISCARD IT IMMEDIATELY. LOOSE LOCKWIRE CAN CUT YOU OR MAKE YOU BLIND, AND/OR CAN CAUSE DAMAGE.
CAUTION:
MAKE SURE THAT THE FLUID DOES NOT STAY ON THE AIRCRAFT STRUCTURE. IF THE FLUID GETS ON THE AIRCRAFT STRUCTURE, WASH IT OFF IMMEDIATELY WITH SOAP AND WATER.
(1) Remove and discard the lockwire from the plug (1) and then remove the plug (1). (2) Remove and discard the retainer (2) and the packing (3) from the plug (1).
(3) Carefully remove and discard the filter (4) and the packing (5) from the manifold.
Alternate-Brake Servovalve Manifold Filter Detail