Removal of the MLG Axle Adaptor-Sleeves

TASK 32-42-71-000-001-A
Removal of the MLG Axle Adaptor-Sleeves

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

ZONE: 731
ZONE: 741
FIN: 2631GM
FIN: 2632GM
FIN: 2633GM
FIN: 2634GM

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY BARRIER(S)
No specific	AR	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
731	L.H MAIN GEAR
741	R.H MAIN GEAR

C. Referenced Information

REFERENCE	DESIGNATION
TASK 32-00-00-481-001-A	Installation of the Safety Devices on the Landing Gears
TASK 32-41-11-000-006-A	Removal of the MLG Wheel
TASK 32-42-27-000-001-A	Removal of the Brake
MLG Axle Adaptor-Sleeve - Removal/Installation

3. Job Set-up
Subtask 32-42-71-941-050-A

A. Safety Precautions
(1) As necessary, use the applicable SAFETY BARRIERS, specified by the operator's instructions and your local regulations.
(2) Make sure that the ground safety locks are on the landing gear (Ref. AMM TASK 32-00-00-481-001).
(3) On the panel 400VU:

make sure that the landing-gear control-lever 6GA is in the DOWN position
put a WARNING NOTICE(S) in position to tell persons not to operate the landing gear.

(4) Put a WARNING NOTICE(S) in position to tell persons not to operate the brakes.

Subtask 32-42-71-010-050-A

B. Get Access
(1) Remove the applicable MLG wheel (Ref. AMM TASK 32-41-11-000-006).
(2) Remove the applicable brake unit (Ref. AMM TASK 32-42-27-000-001).

4. Procedure
Subtask 32-42-71-020-050-A ** ON A/C NOT FOR ALL

A. Removal of the MLG Axle Adaptor-Sleeve
(1) Carefully remove the circlip (3). Make sure that you do not damage the axle threads.
(2) Remove the axle sleeve (2).

Subtask 32-42-71-020-050-C ** ON A/C NOT FOR ALL

A. Removal of the MLG Axle Adaptor-Sleeve
(1) Carefully remove the retaining ring (3). Make sure that you do not damage the axle threads.
(2) Remove the axle sleeve (2).

[Rev.10 from 2021] 2026.04.01 00:48:23 UTC