Remove MLG Aft Pintle Pin and Nut for Special Detailed Inspection in Shop

TASK 32-11-11-920-002-A
Remove MLG Aft Pintle Pin and Nut for Special Detailed Inspection in Shop

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

WARNING: OBEY THE HYDRAULIC SAFETY PROCEDURES.

ZONE: 731
ZONE: 741

1. Reason for the Job
Refer to the MPD TASK: 321100-21
REMOVE MLG AFT PINTLE PIN AND NUT FOR SPECIAL DETAILED INSPECTION IN SHOP.

NOTE: It is necessary to do this task and MPD task 321111-01 at the same time.

2. Job Set-up Information
A. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
731	L.H MAIN GEAR
741	R.H MAIN GEAR

B. Referenced Information

REFERENCE	DESIGNATION
TASK 32-11-11-000-001-A	Removal of the MLG Leg Assembly
TASK 32-11-11-400-001-A	Installation of the MLG Leg Assembly

3. Job Set-up
Subtask 32-11-11-941-077-A

A. No special job set-up is necessary for this task.

4. Procedure
Subtask 32-11-11-960-050-A

A. Remove the MLG aft pintle pins and nuts for workshop maintenance.
(1) If the MLG leg assemblies are not removed, remove them (Ref. AMM TASK 32-11-11-000-001).
(2) Send the MLG aft pintle pins and nuts to the workshop.

NOTE: The MLG pintle pins and nuts will be removed and installed, when you do MPD task 321111-01.

(3) If the MLG leg assemblies are not installed, install them (Ref. AMM TASK 32-11-11-400-001).

5. Close-up
Subtask 32-11-11-942-070-A

A. No special close-up is necessary for this task.

[Rev.10 from 2021] 2026.04.01 00:39:50 UTC