Removal of the Cursor Control Device (CCD)

TASK 31-61-14-000-801-A
Removal of the Cursor Control Device (CCD)

ZONE: 211
ZONE: 212
FIN: 35WT ** ON A/C NOT FOR ALL
FIN: 36WT ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
211	COCKPIT
212	COCKPIT

C. Referenced Information

REFERENCE	DESIGNATION
Cursor Control Device (CCD)

3. Job Set-up
Subtask 31-61-14-865-050-A ** ON A/C NOT FOR ALL

A. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
FOR FIN: 35WT (CCD CAPTAIN)
121VU	OANS CCD CAPT	37WT	L11
FOR FIN: 36WT (CCD FIRST OFFICER)
121VU	OANS CCD F/O	38WT	L09

4. Procedure
Subtask 31-61-14-020-050-A ** ON A/C NOT FOR ALL

A. Removal of the CCD
(1) remove the three screws (1).
(2) Release the CCD (4) from the cover (2) and disconnect the electrical connector (3).
(3) Remove the CCD (4) from the cover (2).
(4) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.

[Rev.10 from 2021] 2026.04.01 00:38:13 UTC