W DOC AIRBUS | AMM A320F

Installation of the Personal Computer Memory Card (PCMCIA) of the FDIMU/DMU


TASK 31-36-00-400-001-A
Installation of the Personal Computer Memory Card (PCMCIA) of the FDIMU/DMU


ZONE: 128
ZONE: 210
FIN: 1TV ** ON A/C NOT FOR ALL
FIN: 10TV ** ON A/C NOT FOR ALL
1. Reason for the Job
Self explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
1
ACCESS PLATFORM 2M (6 FT)
No specific
1
PCMCIA-CARD
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
128
REAR AVIONIC COMPARTMENT
210
CKPT,FWD COMPT BHD TO FLT COMPT BULKHEAD
824
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 24-41-00-861-002-A
Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01
Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02
Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 24-41-00-862-002-A
De-energize the Aircraft Electrical Circuits Supplied from the External Power
TASK 24-41-00-862-002-A-01
De-energize the Aircraft Electrical Circuits Supplied from the APU
TASK 24-41-00-862-002-A-02
De-energize the Aircraft Electrical Circuits Supplied from the Engine 1(2)
TASK 52-41-00-010-002-A
Open the Avionics Compartment Doors for Access
TASK 52-41-00-410-002-A
Close the Avionics Compartment Doors after Access
F PCMCIA Card ** ON A/C NOT FOR ALL
3. Job Set-up
Subtask 31-36-00-861-068-A
A. Aircraft Maintenance Configuration
   (1) Make sure that the aircraft electrical circuits are energized (Ref. AMM TASK 24-41-00-861-002).
Subtask 31-36-00-010-062-A
B. Get Access
   (1) Make sure that the ACCESS PLATFORM 2M (6 FT) is in position at access door 824 in zone 128.
   (2) Make sure that access door 824 is open (Ref. AMM TASK 52-41-00-010-002).
Subtask 31-36-00-865-160-A
C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged:
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
121VUAIDS/DMU4TVK15
** ON A/C NOT FOR ALL
121VUAIDS & RCDR/FDIMU5TVK15
** ON A/C NOT FOR ALL
121VUAIDS & RCDR/FDIMU5TVK38
4. Procedure
Subtask 31-36-00-400-051-A ** ON A/C NOT FOR ALL
A. Install the Personal Computer Memory Card (PCMCIA) of the DMU
   (1) Make sure that both LED's (1) and (2) are off.
   (2) Open the flap (5) to get access to the PCMCIA-CARD (4).
CAUTION: MAKE SURE THAT THE PCMCIA CARD IS CORRECTLY ALIGNED BEFORE YOU INSTALL IT IN THE RELATED SLOT. ALSO DO NOT USE FORCE TO INSTALL IT. IF YOU DO NOT OBEY THESE INSTRUCTIONS, DAMAGE TO THE EQUIPMENT CAN OCCUR.
NOTE: The PCMCIA must be inserted with the NOTCH on the bottom.
   (3) Insert the PCMCIA-CARD (4) until the card is flush with the gray button (3).
   (4) Close the flap (5) of the PCMCIA interface.
Subtask 31-36-00-400-051-C ** ON A/C NOT FOR ALL
A. Install the Personal Computer Memory Card (PCMCIA)
CAUTION: MAKE SURE THAT THE PCMCIA CARD IS CORRECTLY ALIGNED BEFORE YOU INSTALL IT IN THE RELATED SLOT. ALSO DO NOT USE FORCE TO INSTALL IT. IF YOU DO NOT OBEY THESE INSTRUCTIONS, DAMAGE TO THE EQUIPMENT CAN OCCUR.
   (1) Open the door.
NOTE: The PCMCIA must be inserted with the NOTCH on the bottom.
   (2) Insert the PCMCIA-CARD carefully into the interface until the card has connected with the contacts.
   (3) Close the door.
Subtask 31-36-00-400-051-E ** ON A/C NOT FOR ALL
A. Install the Personal Computer Memory Card (PCMCIA)
F PCMCIA Card ** ON A/C NOT FOR ALL
   (1) Make sure that both LEDs (1) and (2) are off.
CAUTION: MAKE SURE THAT THE PCMCIA CARD IS CORRECTLY ALIGNED BEFORE YOU INSTALL IT IN THE RELATED SLOT. ALSO DO NOT USE FORCE TO INSTALL IT. IF YOU DO NOT OBEY THESE INSTRUCTIONS, DAMAGE TO THE EQUIPMENT CAN OCCUR.
   (2) Open the access door (3).
NOTE: The PCMCIA must be inserted with the NOTCH on the bottom.
   (3) Insert the PCMCIA-CARD carefully into the interface until the card has connected with the contacts.
   (4) Close the access door (3).
Subtask 31-36-00-400-051-G ** ON A/C NOT FOR ALL
A. Install the Personal Computer Memory Card (PCMCIA)
F PCMCIA Card ** ON A/C NOT FOR ALL
   (1) Make sure that the LEDs (1) and (2) are off.
CAUTION: MAKE SURE THAT THE PCMCIA CARD IS CORRECTLY ALIGNED BEFORE YOU INSTALL IT IN THE RELATED SLOT. ALSO DO NOT USE FORCE TO INSTALL IT. IF YOU DO NOT OBEY THESE INSTRUCTIONS, DAMAGE TO THE EQUIPMENT CAN OCCUR.
   (2) Open the access door (3).
NOTE: The PCMCIA must be inserted with the NOTCH on the bottom.
   (3) Make sure that the PCMCIA-CARD is put with the NOTCH on the bottom.
   (4) Carefully put the PCMCIA-CARD into the interface until the card has connected with the contacts.
   (5) Close the access door (3).
5. Close-up
Subtask 31-36-00-865-161-A
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
121VUAIDS/DMU4TVK15
** ON A/C NOT FOR ALL
121VUAIDS & RCDR/FDIMU5TVK15
** ON A/C NOT FOR ALL
121VUAIDS & RCDR/FDIMU5TVK38
Subtask 31-36-00-710-066-A ** ON A/C NOT FOR ALL
B. Test of the Correct PCMCIA-Card Function
   (1) Make sure that the aircraft is in ground configuration (both engines stopped and landing gear compressed).
   (2) On the MCDU push the Line Select Key (LSK) adjacent to <AIDS.
  • The AIDS initial menu comes on.
   (3) Push the LSK adjacent to PCMCIA>.
  • The AIDS DISK MENU comes on.
   (4) Push the LSK adjacent to <DISK IDENT.
  • The AIDS DISK IDENT menu comes on.
   (5) Push the LSK adjacent to DISK MAINTENANCE WORD.
  • The Disk Maintenance Word is 00000000.
  • No failure shows.
   (6) On the MCDU push the MCDU Main Menu key.
  • The MCDU Main Menu comes on.
Subtask 31-36-00-710-066-C ** ON A/C NOT FOR ALL
B. Test of the Correct PCMCIA-Card Function
   (1) Make sure that the aircraft is in ground configuration (both engines stopped and landing gear compressed).
   (2) On the MCDU push the Line Select Key (LSK) adjacent to <AIDS.
  • The AIDS initial menu comes on.
   (3) Push the LSK adjacent to PCMCIA>.
  • The AIDS DISK MENU comes on.
   (4) Push the LSK adjacent to <DISK IDENT.
  • The AIDS DISK IDENT menu comes on.
   (5) Push the LSK adjacent to DISK MAINTENANCE WORD.
  • The Disk Maintenance Word is 00000000.
  • No failure shows.
   (6) On the MCDU push the MCDU Main Menu key.
  • The MCDU Main Menu comes on.
Subtask 31-36-00-710-066-D ** ON A/C NOT FOR ALL
B. Test of the Correct PCMCIA-Card Function
   (1) Make sure that the aircraft is in ground configuration (both engines stopped and landing gear compressed).
   (2) On the MCDU push the Line Select Key (LSK) adjacent to the <AIDS indication.
  • The AIDS menu shows.
   (3) Push the LSK adjacent to the PCMCIA> indication.
  • The AIDS: PCMCIA MAIN MENU shows.
   (4) Push the LSK adjacent to the <QAR DATA indication.
  • The AIDS: PCMCIA QAR STATUS shows.
   (5) Push the LSK adjacent to the RETURN indication.
  • The AIDS: PCMCIA MAIN MENU shows.
   (6) Push the LSK adjacent to the <SAR DATA indication.
  • The AIDS: PCMCIA SAR STATUS shows.
   (7) Push the LSK adjacent to the RETURN indication.
  • The AIDS: PCMCIA MAIN MENU shows.
   (8) Push the LSK adjacent to the DAR DATA> indication.
  • The AIDS: PCMCIA DAR STATUS shows.
   (9) Push the LSK adjacent to the RETURN indication.
  • The AIDS: PCMCIA MAIN MENU shows.
   (10) Push the LSK adjacent to the REPORT DATA> indication.
  • The AIDS: PCMCIA RPT STATUS shows.
   (11) On the MCDU push the MCDU Main Menu key.
  • The MCDU Main Menu shows.
Subtask 31-36-00-710-066-F ** ON A/C NOT FOR ALL
B. Test of the Correct PCMCIA-Card Function
   (1) Make sure that the aircraft is in ground configuration (both engines stopped and landing gear compressed).
   (2) On the MCDU push the line select key adjacent to <AIDS.
  • The AIDS initial menu comes on.
   (3) Push the line select key adjacent to PCMCIA>.
  • The AIDS DISK MENU comes on.
   (4) Push the line select key adjacent to <DISK IDENT.
  • The AIDS DISK IDENT menu comes on.
   (5) Push the line select key adjacent to DISK MAINTENANCE WORD.
  • The Disk Maintenance Word is 00000000.
  • No failure shows.
   (6) On the MCDU push the MCDU Main Menu key.
  • The MCDU Main Menu comes on.
Subtask 31-36-00-410-061-A
C. Close Access
   (1) Make sure that the work area is clean and clear of tools and other items.
   (2) Close access door 824 (Ref. AMM TASK 52-41-00-410-002).
   (3) Remove the access platform(s).
Subtask 31-36-00-862-068-A
D. Aircraft Maintenance Configuration
   (1) De-energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-862-002).
[Rev.10 from 2021] 2026.04.01 00:35:48 UTC