W DOC AIRBUS | AMM A320F

Removal of the Potable-Water Ice-Protection Control-Unit


TASK 30-73-35-000-001-A
Removal of the Potable-Water Ice-Protection Control-Unit


NOTE: The procedure is the same for both control units.
FIN: 33DW ** ON A/C NOT FOR ALL
1. Reason for the Job
Self explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
CAP - BLANKING
No specific
AR
SAFETY CLIP - CIRCUIT BREAKER
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
152FW
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 24-42-00-861-001-A
Energize the Ground Service Network from the External Power
TASK 25-55-11-000-003-A
Removal of the Sidewall Panels in the Aft Cargo Compartment - FR47/FR59
TASK 52-30-00-860-001-A
Open the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump
3. Job Set-up
Subtask 30-73-35-861-050-A ** ON A/C NOT FOR ALL
A. Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).
Subtask 30-73-35-865-054-A ** ON A/C NOT FOR ALL
B. Open, safety and tag this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
2001VUPOT/WASTE WIP-HEATER-LINE51DWD04
2001VUPOT/WASTE WIP-HEATER-LINE31DWD03
2001VUPOT/WASTE WIP-HEATER-CTL32DWD02
Subtask 30-73-35-010-050-A ** ON A/C NOT FOR ALL
C. Get Access
   (1) Open the aft cargo-compartment door (Ref. AMM TASK 52-30-00-860-001).
   (2) Set the CARGO COMP LT switch 8LU to ON.
   (3) Remove the sidewall panel 152FW (Ref. AMM TASK 25-55-11-000-003).
4. Procedure
Subtask 30-73-35-020-050-A ** ON A/C NOT FOR ALL
A. Removal of a control unit (typical)
CAUTION: MAKE SURE THAT THE ELECTRICAL CONNECTORS ARE CLEAN BEFORE YOU DISCONNECT OR CONNECT THEM. CONTAMINATION ON THE ELECTRICAL CONNECTORS CAN CAUSE DAMAGE TO EQUIPMENT.
   (1) Disconnect the electrical connector (1) from the control unit (2).
   (2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
   (3) Remove the screws (4), the washers (5) and the brackets (3) which hold the control unit (2) in position.
   (4) Remove the control unit (2) from its support (6).
[Rev.10 from 2021] 2026.04.01 00:32:50 UTC