Removal of the Reservoir Pressure Switch of the Green Hydraulic System

TASK 29-34-11-000-001-A
Removal of the Reservoir Pressure Switch of the Green Hydraulic System

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

FIN: 1384GH

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE
No specific	AR	CAP - BLANKING
No specific	AR	PLUG - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	2	WARNING NOTICE(S)

B. Referenced Information

REFERENCE	DESIGNATION
TASK 29-00-00-864-001-A	Put the Related Hydraulic System in the Depressurized Configuration before Maintenance Action
TASK 29-00-00-910-002-A	Safety Procedures of the Hydraulic System
TASK 29-14-00-614-001-A	Depressurization of the Hydraulic Reservoirs
TASK 29-23-00-860-001-A	Disconnection of the Isolation Coupling of the Power Transfer Unit (PTU)
TASK 32-12-00-010-001-A	Open the Main Gear Doors for Access
Air Pressure Switch

3. Job Set-up
Subtask 29-34-11-865-050-A

A. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
121VU	HYDRAULIC/HYD POWER/Y	3803GX	N30
121VU	HYDRAULIC/G HYD/PUMP ENG1/MONG	1702GK	R34
** ON A/C ALL
121VU	HYDRAULIC/LOW/LVL/IND	1832GQ	N32
121VU	HYDRAULIC/HYD/QTY/IND	1831GQ	P35
** ON A/C NOT FOR ALL
121VU	HYDRAULIC/HYD POWER/Y	3803GX	N31
121VU	HYDRAULIC/G HYD/PUMP ENG1/MONG	1702GK	R33
** ON A/C ALL
123VU	Y HYD/ELEC/PUMP	3802GX	AB06
123VU	Y HYD/ELEC/ELEC PUMP/NORM	3801GX	AB03

Subtask 29-34-11-010-050-A

B. Open the main doors of the main gear (Ref. AMM TASK 32-12-00-010-001).

Subtask 29-34-11-860-050-A

C. Aircraft Maintenance Configuration

WARNING: OBEY THE HYDRAULIC SAFETY PROCEDURES.

(1) Obey the hydraulic safety procedures (Ref. AMM TASK 29-00-00-910-002).
(2) Put the WARNING NOTICE(S) in position to tell persons not to pressurize the Green hydraulic system:

In the cockpit on the hydraulic section of the overhead panel,
On the ground service panel of the Green hydraulic system.

(3) Make sure that the Green hydraulic system is depressurized and put it in the maintenance configuration.
(Ref. AMM TASK 29-00-00-864-001).
(4) Depressurize the reservoir of the Green hydraulic system (Ref. AMM TASK 29-14-00-614-001).
(5) Put an ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE in position.
(6) Disconnect the isolation coupling of the power transfer unit (PTU) (Ref. AMM TASK 29-23-00-860-001).

4. Procedure
Subtask 29-34-11-020-050-A

A. Removal of the Reservoir Pressure Switch
(1) Disconnect the electrical connector (1) from the pressure switch (2).
(2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Remove the nut (4), the washer (6) and the bolt (7) and remove the bonding jumper (5).
(4) Cut and remove the lockwire from the pressure switch (2).
(5) Remove the pressure switch (2) from the reservoir and discard the O-ring (3).
(6) Put a PLUG - BLANKING in the open end of the pressure switch (2) and in the port on the top of the reservoir.

[Rev.10 from 2021] 2026.04.01 00:28:04 UTC