Removal of the Engine-Pump Case-Drain Filter
TASK 29-11-43-000-040-A
Removal of the Engine-Pump Case-Drain Filter
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Work Zones and Access Panels
C. Referenced Information
3. Job Set-up
Subtask 29-11-43-860-057-A ** ON A/C NOT FOR ALL
Subtask 29-11-43-020-056-A ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.04.01 00:16:03 UTC
Removal of the Engine-Pump Case-Drain Filter
WARNING:
OBEY THE HYDRAULIC SAFETY PROCEDURES.
WARNING:
DO NOT TOUCH THE HYDRAULIC SYSTEM COMPONENTS FOR A SHORT TIME AFTER THE ENGINE IS SHUTDOWN. THE ENGINE COMPONENTS STAY HOT FOR SOME TIME AND CAN CAUSE INJURY.
CAUTION:
DO NOT LET HYDRAULIC FLUID FALL ON THE ENGINE. UNWANTED HYDRAULIC FLUID MUST BE REMOVED IMMEDIATELY WITH A CLEAN LINT FREE CLOTH. THE FLUID CAN CAUSE DAMAGE TO THE SURFACE PROTECTION AND TO SOME PARTS.
FIN: 1084GM ** ON A/C NOT FOR ALL
1. Reason for the JobSelf explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | 1 | ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE |
| No specific | AR | CONTAINER 5 L (1.32 USGAL) |
| No specific | AR | COVER - BLANKING |
| No specific | AR | WARNING NOTICE(S) |
| ZONE/ACCESS | ZONE DESCRIPTION |
|---|---|
| 437AL |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 29-10-00-864-001-A | Depressurize the Green Hydraulic System |
| TASK 29-14-00-614-001-A | Depressurization of the Hydraulic Reservoirs |
| TASK 71-13-00-010-040-A | Opening of the Fan Cowl Doors |
Subtask 29-11-43-860-057-A ** ON A/C NOT FOR ALL
A. Aircraft Maintenance Configuration
(1) Depressurize the Green hydraulic system (Ref. AMM TASK 29-10-00-864-001).
(2) Depressurize the Green hydraulic reservoir (Ref. AMM TASK 29-14-00-614-001).
(3) Put WARNING NOTICE(S) in position to tell persons not to pressurize the Green hydraulic system:
Subtask 29-11-43-941-054-A ** ON A/C NOT FOR ALL (1) Depressurize the Green hydraulic system (Ref. AMM TASK 29-10-00-864-001).
(2) Depressurize the Green hydraulic reservoir (Ref. AMM TASK 29-14-00-614-001).
(3) Put WARNING NOTICE(S) in position to tell persons not to pressurize the Green hydraulic system:
- on the ground service panel 197CB.
B. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(3) Put WARNING NOTICE(S) in position to tell persons not to pressurize the Green hydraulic system:
(6) Put a CONTAINER 5 L (1.32 USGAL) under the case drain filter.
Subtask 29-11-43-010-052-A ** ON A/C NOT FOR ALL (1) On the center pedestal, on the ENG panel 115VU:
- put WARNING NOTICE(S) to tell persons not to start the engine.
(3) Put WARNING NOTICE(S) in position to tell persons not to pressurize the Green hydraulic system:
- in the cockpit, on the HYD section of the overhead panel 40VU.
- make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(6) Put a CONTAINER 5 L (1.32 USGAL) under the case drain filter.
C. Get Access
(1) Open the left fan-cowl door 437AL (Ref. AMM TASK 71-13-00-010-040).
(2) Put the ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position at the engine.
4. Procedure(1) Open the left fan-cowl door 437AL (Ref. AMM TASK 71-13-00-010-040).
(2) Put the ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position at the engine.
Subtask 29-11-43-020-056-A ** ON A/C NOT FOR ALL
A. Removal of the Case Drain Filter
BEFORE SB RA32029-5
(1) Disconnect the hoses from the filter module (5).
(2) Put COVER - BLANKING on the disconnected hose couplings and the filter module unions (10).
(3) Remove the lockwire from the four bolts (15).
(4) Remove the bolts (15) and the washers (20) that attach the filter module (5) to the filter support bracket.
(5) Remove the filter module (5).
(6) Remove the two unions (10) and the two packings (7) from the filter module (5).
(7) Put blanking covers on the unions (10) and the filter module ports.
Subtask 29-11-43-020-057-A ** ON A/C NOT FOR ALL BEFORE SB RA32029-5
(1) Disconnect the hoses from the filter module (5).
(2) Put COVER - BLANKING on the disconnected hose couplings and the filter module unions (10).
(3) Remove the lockwire from the four bolts (15).
(4) Remove the bolts (15) and the washers (20) that attach the filter module (5) to the filter support bracket.
(5) Remove the filter module (5).
(6) Remove the two unions (10) and the two packings (7) from the filter module (5).
(7) Put blanking covers on the unions (10) and the filter module ports.
B. Removal of the Case Drain Filter
AFTER SB RA32029-5
(1) Disconnect the hoses from the filter module (5).
(2) Put COVER - BLANKING on the disconnected hose couplings, the filter module unions (10) and the elbow (35).
(3) Remove the lockwire from the four bolts (15).
(4) Remove the bolts (15) and the washers (20) that attach the filter module (5) to the filter support bracket.
(5) Remove the filter module (5).
(6) Remove the union (10), the packing (7), the elbow (35), the nut (30) and packing (25) from the filter module.
(7) Put blanking covers on the union (10), the elbow (35) and the filter module ports.
AFTER SB RA32029-5
(1) Disconnect the hoses from the filter module (5).
(2) Put COVER - BLANKING on the disconnected hose couplings, the filter module unions (10) and the elbow (35).
(3) Remove the lockwire from the four bolts (15).
(4) Remove the bolts (15) and the washers (20) that attach the filter module (5) to the filter support bracket.
(5) Remove the filter module (5).
(6) Remove the union (10), the packing (7), the elbow (35), the nut (30) and packing (25) from the filter module.
(7) Put blanking covers on the union (10), the elbow (35) and the filter module ports.
Engine-Pump Case-Drain Filter