W DOC AIRBUS | AMM A320F

Removal of the Attitude Monitor


TASK 28-43-24-000-001-A
Removal of the Attitude Monitor


WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
  • THE FLIGHT CONTROLS
  • THE FLIGHT CONTROL SURFACES
  • THE LANDING GEAR AND THE RELATED DOORS
  • COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.
WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.
FIN: 39QM ** ON A/C NOT FOR ALL
1. Reason for the Job
Self Explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
SAFETY BARRIER(S)
No specific
AR
WARNING NOTICE(S)
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
192MB
 C. Referenced Information
REFERENCE
DESIGNATION
F Attitude Monitor ** ON A/C NOT FOR ALL
3. Job Set-up
Subtask 28-43-24-941-051-A ** ON A/C NOT FOR ALL
A. Safety Precautions
   (1) Put the SAFETY BARRIER(S) in position.
   (2) Put a WARNING NOTICE(S) in the cockpit to tell persons not to operate the landing gear or the landing gear doors.
Subtask 28-43-24-010-050-A ** ON A/C NOT FOR ALL
B. Get Access
   (1) Open the access panel 192MB.
NOTE: Do not keep the door open longer than necessary because the battery can discharge.
4. Procedure
Subtask 28-43-24-020-050-A ** ON A/C NOT FOR ALL
CAUTION: DO NOT LOOSEN OR REMOVE THE FOUR SCREWS THAT HOLD THE COVER PLATE. THIS CAN CHANGE THE MOUNTING DATUM OF THE ATTITUDE MONITOR.
A. Removal of the Attitude Monitor

NOTE: Record the position of the washers (3) before you remove the attitude monitor. This is to make sure that the washers (3) are installed in the position that they were removed from.

   (1) Remove the three screws (1).
   (2) Carefully remove the attitude monitor (2) and the three washers (3) from the aircraft.
[Rev.10 from 2021] 2026.04.02 06:18:14 UTC