Removal of the ACT Fuel Inlet Valve Actuator
TASK 28-28-54-000-001-A
Removal of the ACT Fuel Inlet Valve Actuator
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Referenced Information
3. Job Set-up
Subtask 28-28-54-860-050-A ** ON A/C NOT FOR ALL
Subtask 28-28-54-020-050-A ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.04.02 06:18:00 UTC
Removal of the ACT Fuel Inlet Valve Actuator
WARNING:
OBEY THE FUEL SAFETY PROCEDURES.
1. Reason for the JobSelf explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | AR | CAP - BLANKING |
| No specific | AR | SAFETY CLIP - CIRCUIT BREAKER |
| No specific | 1 | WARNING NOTICE(S) |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 24-42-00-861-001-A | Energize the Ground Service Network from the External Power |
| TASK 28-00-00-910-001-A | Fuel Safety Procedures |
| TASK 28-11-27-000-001-A | Removal of the Additional Center Tank (ACT) |
| TASK 28-11-49-000-001-A | Removal of the ACT Integrated Impact Wall |
Subtask 28-28-54-860-050-A ** ON A/C NOT FOR ALL
A. Aircraft Maintenance Configuration
(1) Obey the fuel safety procedures (Ref. AMM TASK 28-00-00-910-001).
(2) Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).
(3) On refuel/defuel control panels 801VU and 800VU and on fuel control panel 40VU:
(a) Put a WARNING NOTICE(S) to tell persons not to operate the refuel/defuel system.
Subtask 28-28-54-010-051-A ** ON A/C NOT FOR ALL (1) Obey the fuel safety procedures (Ref. AMM TASK 28-00-00-910-001).
(2) Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).
(3) On refuel/defuel control panels 801VU and 800VU and on fuel control panel 40VU:
(a) Put a WARNING NOTICE(S) to tell persons not to operate the refuel/defuel system.
B. Get Access
(1) Remove the integrated impact wall from the aft cargo-compartment (Ref. AMM TASK 28-11-49-000-001).
Subtask 28-28-54-010-051-B ** ON A/C NOT FOR ALL (1) Remove the integrated impact wall from the aft cargo-compartment (Ref. AMM TASK 28-11-49-000-001).
B. Get Access
(1) Get access to the actuator of the ACT2:
(a) Remove the integrated impact wall from the aft cargo-compartment (Ref. AMM TASK 28-11-49-000-001).
(2) Get access to the actuator of the ACT1:
(a) Remove the ACT2 from the aft cargo-compartment (Ref. AMM TASK 28-11-27-000-001).
Subtask 28-28-54-865-050-A ** ON A/C NOT FOR ALL (1) Get access to the actuator of the ACT2:
(a) Remove the integrated impact wall from the aft cargo-compartment (Ref. AMM TASK 28-11-49-000-001).
(2) Get access to the actuator of the ACT1:
(a) Remove the ACT2 from the aft cargo-compartment (Ref. AMM TASK 28-11-27-000-001).
C. Open, safety and tag this(these) circuit breaker(s):
4. Procedure| PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 121VU | ACT1/REFUEL & SPLY | 33QU | L29 |
| 121VU | FUEL/HI/LVL/SPLY | 1QJ | L25 |
| 121VU | FUEL/RFL/DFL/SPLY | 2QU | L24 |
| 121VU | FUEL/RFL/DFL/XFR/DEFUEL/VALVE | 1QU | L23 |
| 121VU | ACT XFR VALVE MAN CTL | 30QH | N29 |
| 121VU | ACT1/CTL & SPLY | 9QH | P29 |
| 121VU | ACT PUMP SUPPLY | 25QH | Q29 |
Subtask 28-28-54-020-050-A ** ON A/C NOT FOR ALL
A. Removal of the Actuator of the ACT Fuel Inlet Valve.
(1) Disconnect the electrical connector (5) from the receptacle (6).
(2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Loosen the screw (3), then open and remove the V-clamp (2) from the actuator (1).
(4) Remove the actuator (1) from the ACT fuel inlet valve (4).
(1) Disconnect the electrical connector (5) from the receptacle (6).
(2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Loosen the screw (3), then open and remove the V-clamp (2) from the actuator (1).
(4) Remove the actuator (1) from the ACT fuel inlet valve (4).
Actuator of the ACT Fuel Inlet Valve