Removal of the ACT Fuel Inlet-Valve(s)

TASK 28-28-34-000-003-A
Removal of the ACT Fuel Inlet-Valve(s)

WARNING: OBEY THE FUEL SAFETY PROCEDURES.

WARNING: BEFORE YOU DO WORK IN OR NEAR A FUEL TANK, MAKE SURE THAT YOU OBEY ALL THE SAFETY PROCEDURES. THIS WILL PREVENT INJURY TO PERSONS AND/OR DAMAGE TO THE AIRCRAFT.

WARNING: BE CAREFUL NOT TO GET AIRCRAFT FUEL IN YOUR MOUTH OR IN YOUR EYES. IF YOU GET FUEL ON YOUR SKIN OR ON YOUR CLOTHES, FLUSH IT IMMEDIATELY WITH WATER. IF NECESSARY, GET MEDICAL HELP. AIRCRAFT FUEL IS POISONOUS.

WARNING: DO NOT GET YOUR CLOTHES SOAKED WITH FUEL.

WARNING: MAKE SURE THAT YOU HAVE THE CORRECT FIRE FIGHTING EQUIPMENT AVAILABLE.

ZONE: 150
ZONE: 160
FIN: 228QM1 ** ON A/C NOT FOR ALL
FIN: 228QM2 ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
150	AFT CARGO COMPARTMENT FWD PRESS BULKHEAD TO AFT BULKHEAD OF AFT CARGO COMPARTMENT
160	BULK CARGO COMPARTMENT AFT BULKHEAD OF AFT CARGO COMPARTMENT TO AFT BULKHEAD OF BULK CARGO COMPARTMENT

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 28-00-00-910-001-A	Fuel Safety Procedures
TASK 28-10-00-910-001-A	Safety Procedures When You Do Work in a Fuel Tank
TASK 28-25-00-650-001-A	Pressure Defuel
TASK 28-25-00-650-005-A	To Drain the Remaining Fuel from the Additional Center Tank (ACT)
FOR [228QM1] (VALVE-FUEL INLET, ACT1)
TASK 28-11-27-000-002-A	Removal of Additional Center Tank No.1 (ACT AFT1)
FOR [228QM2] (VALVE-FUEL INLET, ACT2)
TASK 28-11-27-000-003-A	Removal of the Additional Center Tank No.2 (ACT AFT2)

3. Job Set-up
Subtask 28-28-34-860-054-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Obey the fuel safety procedures (Ref. AMM TASK 28-00-00-910-001).
(2) Obey the safety procedures when you work in a fuel tank (Ref. AMM TASK 28-10-00-910-001).
(3) Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).
(4) Transfer the fuel from the Additional Center Tank(s) (ACT)(s) to the center tank (Ref. AMM TASK 28-25-00-650-001).
(5) Drain the remaining fuel from the ACT(s) (Ref. AMM TASK 28-25-00-650-005).
(6) On refuel/defuel control panels 801VU and 800VU and on fuel control panel 40VU:
(a) Put the WARNING NOTICE(S) in position to tell persons not to operate the refuel/defuel system.

Subtask 28-28-34-010-054-C ** ON A/C NOT FOR ALL

B. Get Access
(1) FOR [228QM1] (VALVE-FUEL INLET, ACT1)
(a) Remove the ACT AFT1 (Ref. AMM TASK 28-11-27-000-002).
(2) FOR [228QM2] (VALVE-FUEL INLET, ACT2)
(a) Remove the ACT AFT2 (Ref. AMM TASK 28-11-27-000-003).

4. Procedure
Subtask 28-28-34-020-052-B ** ON A/C NOT FOR ALL

A. Removal of the ACT Fuel Inlet-Valve

CAUTION: DO THIS PROCEDURE ONLY IN THE WORKSHOP. IF YOU DO NOT OBEY THIS INSTRUCTION, DAMAGE TO THE BLADDER TANK CAN OCCUR.

(1) Send the ACT(s) to the workshop for removal of the ACT(s) fuel inlet-valve(s).

[Rev.10 from 2021] 2026.04.02 06:17:56 UTC