Removal of the Center-Tank Defuel/Transfer Valve-Actuator

TASK 28-25-53-000-001-A
Removal of the Center-Tank Defuel/Transfer Valve-Actuator

FIN: 11QU

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 2M (6 FT)
No specific	AR	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
192MB

C. Referenced Information

REFERENCE	DESIGNATION
TASK 32-12-00-010-001-A	Open the Main Gear Doors for Access
Transfer Defuel-Valve Actuator - Center Tank.

3. Job Set-up
Subtask 28-25-53-941-051-A

A. Make sure that on the refuel/defuel control panel 800VU:

the REFUEL switch is in the OFF position,
the OPEN light is off.

Subtask 28-25-53-865-050-A

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
121VU	FUEL/RFL/DFL/SPLY	2QU	L24
121VU	FUEL/RFL/DFL/XFR/DEFUEL/VALVE	1QU	L23
** ON A/C NOT FOR ALL
121VU	FUEL/RFL/DFL/SPLY	2QU	L23
121VU	FUEL/RFL/DFL/XFR/DEFUEL/VALVE	1QU	L22

Subtask 28-25-53-010-051-A

C. Get Access
(1) Open the MLG doors (Ref. AMM TASK 32-12-00-010-001).
(2) Open the access door 192MB to get access to the refuel/defuel panel 800VU.
(3) Put the ACCESS PLATFORM 2M (6 FT) in position at the main landing-gear door.

4. Procedure
Subtask 28-25-53-020-052-A

A. Removal of the Defuel/Transfer Valve-Actuator (11QU)
(1) Disconnect the electrical connector (6) from the defuel/transfer valve-actuator (5).
(2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Release the screw and remove the V-clamp (3) which attaches the defuel/transfer valve-actuator (5) to the mounting flange (1).
(4) Remove the defuel/transfer valve-actuator (5).
(5) Remove and discard the O-ring (2) from the mounting flange (1).
(6) Put a blanking cap on the mounting flange (1) and on the defuel/transfer valve actuator (5).

[Rev.10 from 2021] 2026.04.02 07:03:12 UTC