Removal of the Shroud and the Backing Plate

TASK 28-25-49-000-001-A
Removal of the Shroud and the Backing Plate

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

FIN: 116QM
FIN: 117QM
FIN: 118QM ** ON A/C NOT FOR ALL
FIN: 119QM ** ON A/C NOT FOR ALL

1. Reason for the Job
Self Explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	ACCESS PLATFORM 4M (13 FT)
No specific	AR	SAFETY BARRIER(S)
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)
98D27803500001	1	LOCKING TOOL ZERO POS

B. Referenced Information

REFERENCE	DESIGNATION
TASK 28-00-00-910-001-A	Fuel Safety Procedures
TASK 57-41-37-000-006-A	Removal of the Access Panels
Shroud and Backing Plate - Right Wing ** ON A/C NOT FOR ALL
Shroud and Backing Plate - Left and Right Wings ** ON A/C NOT FOR ALL

3. Job Set-up
Subtask 28-25-49-941-052-A

A. Safety Precautions

WARNING: OBEY THE FUEL SAFETY PROCEDURES.

(1) You must obey the fuel safety procedures when you do work on the fuel system (Ref. AMM TASK 28-00-00-910-001).
(2) As necessary, use the applicable SAFETY BARRIERS, specified by the operator's instructions and your local regulations.
(3) Put a WARNING NOTICE(S) in the cockpit to tell persons not to operate the slat system.
(4) Install the 98D27803500001 LOCKING TOOL ZERO POS on the slat/flap control lever.

Subtask 28-25-49-865-050-A

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1	5CV	B06
** ON A/C NOT FOR ALL
49VU	FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1	5CV	B01
** ON A/C ALL
121VU	FLIGHT CONTROLS/SLT/CTL/SYS2	7CV	R21

Subtask 28-25-49-010-050-A ** ON A/C NOT FOR ALL

C. Get Access
(1) Put the ACCESS PLATFORM 4M (13 FT) in position below the refuel coupling.
(2) Remove the access panel (4) (Ref. AMM TASK 57-41-37-000-006).

Subtask 28-25-49-010-050-B ** ON A/C NOT FOR ALL

C. Get Access
(1) Put the ACCESS PLATFORM 4M (13 FT) in position below the applicable refuel coupling.
(2) Remove the applicable access panel (4) (Ref. AMM TASK 57-41-37-000-006).

4. Procedure
Subtask 28-25-49-020-050-A

A. Removal of the Shroud and the Backing Plate
(1) Remove the bolts (5).
(2) Remove the backing plate (2).
(3) Remove the shroud (3).

[Rev.10 from 2021] 2026.04.02 06:17:41 UTC