W DOC AIRBUS | AMM A320F

Removal of the Fuel Drain Valve


TASK 28-25-44-000-001-A
Removal of the Fuel Drain Valve


WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
  • THE FLIGHT CONTROLS
  • THE FLIGHT CONTROL SURFACES
  • THE LANDING GEAR AND THE RELATED DOORS
  • COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.
WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.
FIN: 31QM
FIN: 32QM
1. Reason for the Job
Self Explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
ACCESS PLATFORM 3M (10 FT)
No specific
AR
PLUG - BLANKING
No specific
AR
SAFETY BARRIER(S)
98D57004014000
1
HOOK-COVER (RIB2-SURGE DOORS)
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
540AB, 640AB
FOR [31QM] (VALVE-FUEL DRAIN, L WING TK)
540AB, 540BZ
FOR [32QM] (VALVE-FUEL DRAIN, R WING TK)
640AB, 640BZ
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 28-10-00-910-001-A
Safety Procedures When You Do Work in a Fuel Tank
TASK 28-10-00-910-002-A
Access to the Fuel Tanks and the Work Areas
TASK 28-25-00-650-001-A
Pressure Defuel
TASK 28-25-00-650-003-A
To Drain Remaining Fuel from the Wing Tanks and the Center Tank
TASK 28-25-00-650-003-A-01
To Drain Remaining Fuel from the Wing Tanks and the Center Tank
TASK 57-27-11-000-001-A
Removal of the Access Panel
FOR [31QM] (VALVE-FUEL DRAIN, L WING TK)
TASK 57-27-11-000-001-A
Removal of the Access Panel
TASK 57-27-12-000-002-A
Removal of the Rib 2 Access Panel 540AZ(640AZ) or 540BZ(640BZ)
FOR [32QM] (VALVE-FUEL DRAIN, R WING TK)
TASK 57-27-11-000-001-A
Removal of the Access Panel
TASK 57-27-12-000-002-A
Removal of the Rib 2 Access Panel 540AZ(640AZ) or 540BZ(640BZ)
3. Job Set-up
Subtask 28-25-44-941-051-A
A. Safety Precautions
WARNING: BEFORE YOU DO WORK IN OR NEAR A FUEL TANK, MAKE SURE THAT YOU OBEY ALL THE SAFETY PROCEDURES. THIS WILL PREVENT INJURY TO PERSONS AND/OR DAMAGE TO THE AIRCRAFT.
   (1) You must obey the fuel safety procedures (Ref. AMM TASK 28-10-00-910-001) when you do work in a fuel tank.
   (2) Put the SAFETY BARRIER(S) in position.
Subtask 28-25-44-650-050-A
B. Fuel Configuration
   (1) Defuel the applicable fuel tank (Ref. AMM TASK 28-25-00-650-001).
   (2) Drain the remaining fuel from the applicable fuel tank (Ref. AMM TASK 28-25-00-650-003).
Subtask 28-25-44-010-050-A ** ON A/C NOT FOR ALL
C. Get Access
   (1) Put the ACCESS PLATFORM 3M (10 FT) in position below the applicable access panel 540AB 640AB.
   (2) Remove the applicable access panel (Ref. AMM TASK 28-10-00-910-002), (Ref. AMM TASK 57-27-11-000-001):
     (a) FOR [31QM] (VALVE-FUEL DRAIN, L WING TK)
remove 540AB
     (b) FOR [32QM] (VALVE-FUEL DRAIN, R WING TK)
remove 640AB.
   (3) Get access to the fuel drain valve through the applicable rear spring-loaded cover in RIB 2:
     (a) FOR [31QM] (VALVE-FUEL DRAIN, L WING TK)
through 540BZ
     (b) FOR [32QM] (VALVE-FUEL DRAIN, R WING TK)
through 640BZ.
   (4) Install the 98D57004014000 HOOK-COVER (RIB2-SURGE DOORS) to keep the spring-loaded cover open.
Subtask 28-25-44-010-050-B ** ON A/C NOT FOR ALL
C. Get Access
   (1) Put the ACCESS PLATFORM 3M (10 FT) in position below the applicable access panel 540AB ( 640AB).
   (2) Remove the applicable access panels (Ref. AMM TASK 28-10-00-910-002):
     (a) FOR [31QM] (VALVE-FUEL DRAIN, L WING TK)
Remove 540AB (Ref. AMM TASK 57-27-11-000-001)
     (b) FOR [32QM] (VALVE-FUEL DRAIN, R WING TK)
Remove 640AB (Ref. AMM TASK 57-27-11-000-001).
   (3) Remove the applicable RIB2 access panels:
     (a) FOR [31QM] (VALVE-FUEL DRAIN, L WING TK)
Remove 540BZ (Ref. AMM TASK 57-27-12-000-002)
     (b) FOR [32QM] (VALVE-FUEL DRAIN, R WING TK)
Remove 640BZ (Ref. AMM TASK 57-27-12-000-002).
4. Procedure
Subtask 28-25-44-020-050-A
A. Removal of the Fuel Drain Valve
   (1) Remove the fuel drain valve (1).
   (2) Remove and discard the O-ring (2).
   (3) Put the PLUG-BLANKING in each disconnected line end.
[Rev.10 from 2021] 2026.04.02 06:17:40 UTC