Installation of the Dampers

TASK 27-92-41-400-003-A
Installation of the Dampers

WARNING: MAKE SURE THAT THE SIDE STICK ASSEMBLY STAYS IN THE VERTICAL POSITION DURING THE MAINTENANCE PROCEDURES. IF NOT THERE IS A RISK OF SKYDROL LEAKAGE. SKYDROL CAN CAUSE INJURY AND/OR DAMAGE.

NOTE: This task is not applicable for the new-generation side-stick unit. For the new-generation side-stick unit, refer to the procedure (Ref. AMM TASK 27-92-41-400-802). To know if the side-stick installed on the aircraft is a new-generation side-stick unit, refer to the procedure (Ref. AMM TASK 27-92-41-860-801).

ZONE: 211
ZONE: 212

1. Reason for the Job
Self Explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
211	COCKPIT
212	COCKPIT
822

C. Expendable Parts

FIG.ITEM	DESIGNATION	IPC-CSN
50	COTTER PINS	AIPC 27-92-41-01-080

D. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 27-92-41-000-001-A	Removal of the Side Stick Assembly
TASK 27-92-41-400-001-A	Installation of the Side Stick Assembly
Dampers

3. Job Set-up
Subtask 27-92-41-860-057-A

A. Aircraft Maintenance Configuration
(1) Make sure that the ground service network is energized (Ref. AMM TASK 24-42-00-861-001).
(2) Make sure that the ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE is in position at the access door 822.
(3) Make sure that the access door 822 is open.
(4) On the battery power center 105VU:

make sure that the protective cover is removed.

(5) Make sure that the side stick assembly is installed on the 98D27303001001 HOLDER - SIDE STICK (Ref. AMM TASK 27-92-41-000-001).

4. Procedure
Subtask 27-92-41-420-052-A

A. Installation of the Side Stick Damper
(1) Remove the string from the damper (55).
(2) Clean the component interfaces and the adjacent area.
(3) Do an inspection of the component interfaces and the adjacent area.
(4) Install the damper (55) on the side stick assembly and the bolts (54).
(5) Install the washers (52), the nuts (51) and tighten.
(6) Install the new AIPC 27-92-41-01-080 COTTER PINS (50) on the nuts (51).

5. Close-up
Subtask 27-92-41-080-052-A

A. Remove the 98D27303001000 HOLDER-SIDE STICK from the side stick assembly.

Subtask 27-92-41-410-052-A

B. Install the side stick assembly (Ref. AMM TASK 27-92-41-400-001).

[Rev.10 from 2021] 2026.03.31 23:59:05 UTC