Removal of the Side Stick Spring Rods

TASK 27-92-41-000-012-A
Removal of the Side Stick Spring Rods

WARNING: MAKE SURE THAT THE SIDE STICK ASSEMBLY STAYS IN THE VERTICAL POSITION DURING THE MAINTENANCE PROCEDURES. IF NOT THERE IS A RISK OF SKYDROL LEAKAGE. SKYDROL CAN CAUSE INJURY AND/OR DAMAGE.

NOTE: This task is not applicable for the new-generation side-stick unit. For the new-generation side-stick unit, refer to the procedure (Ref. AMM TASK 27-92-41-000-802). To know if the side-stick installed on the aircraft is a new-generation side-stick unit, refer to the procedure (Ref. AMM TASK 27-92-41-860-801).

ZONE: 211
ZONE: 212

1. Reason for the Job
This procedure is applicable only for spring rods P/N D27310130000.
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
98D27303001001	1	HOLDER - SIDE STICK
98DNSA20206080	2	RIGGING PIN

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
211	COCKPIT
212	COCKPIT

C. Referenced Information

REFERENCE	DESIGNATION
TASK 27-92-41-000-001-A	Removal of the Side Stick Assembly
Spring Rods

3. Job Set-up
Subtask 27-92-41-010-063-A ** ON A/C NOT FOR ALL

A. Remove the side stick assembly (Ref. AMM TASK 27-92-41-000-001).

Subtask 27-92-41-480-056-A ** ON A/C NOT FOR ALL

B. Installation of the Tools

Spring Rods ** ON A/C NOT FOR ALL

(1) Install the side stick assembly on the 98D27303001001 HOLDER - SIDE STICK.
(2) Install the 98DNSA20206080 RIGGING PIN (7) on the roll transducer unit (8) and on the pitch transducer unit (6).

Subtask 27-92-41-010-064-A ** ON A/C NOT FOR ALL

C. Disconnection of the Side Stick Pitch Damper (Upper Attachment Only)

Spring Rods ** ON A/C NOT FOR ALL

(1) Cut and discard the cotter pin (1) from the nut (2).
(2) Remove the nut (2) and the washer (3).
(3) Remove the bolt (4) and disconnect the damper (9) from the bellcrank (11).

4. Procedure
Subtask 27-92-41-020-061-A ** ON A/C NOT FOR ALL

A. Removal of the Side Stick Spring Rods
(1) Remove and discard the cotter pins (18) from the nuts (15).
(2) Remove the nuts (15) and the washers (16).
(3) Remove the bolts (17) and the spring rods (19).

[Rev.10 from 2021] 2026.03.31 23:59:17 UTC