W DOC AIRBUS | AMM A320F

Removal of the Side Stick Bellows

TASK 27-92-41-000-009-A
Removal of the Side Stick Bellows

NOTE: This task is not applicable for the new-generation side-stick unit. For the new-generation side-stick unit, refer to the procedure (Ref. AMM TASK 27-92-41-000-804). To know if the side-stick installed on the aircraft is a new-generation side-stick unit, refer to the procedure (Ref. AMM TASK 27-92-41-860-801).
ZONE: 211
ZONE: 212
1. Reason for the Job
Self explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
1
ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE
No specific
AR
SAFETY CLIP - CIRCUIT BREAKER
No specific
AR
WARNING NOTICE(S)
98D27903500000
2
PIN-SIDE STICK LOCKING
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
211
COCKPIT
212
COCKPIT
822
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 24-42-00-861-001-A
Energize the Ground Service Network from the External Power
TASK 31-61-14-000-801-A
Removal of the Cursor Control Device (CCD)
F Cover Panel ** ON A/C NOT FOR ALL
F Cover Panel ** ON A/C NOT FOR ALL
F Bellows
3. Job Set-up
Subtask 27-92-41-861-056-A
A. Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).
Subtask 27-92-41-010-069-A
B. Get Access
   (1) Put the ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position at the access door 822.
   (2) Open the access door 822.
   (3) On the battery power center 105VU:
  • loosen the two screws and remove the protective cover.
Subtask 27-92-41-865-058-A
C. Open, safety and tag this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/ELAC1/NORM/SPLY15CE1B11
49VUFLIGHT CONTROLS/SEC1/NORM/SPLY21CE1B08
** ON A/C NOT FOR ALL
49VUCOM/AUDIO/ACP/F/O5RNG07
** ON A/C NOT FOR ALL
49VUCOM/AUDIO/ACP/CAPT4RNG06
** ON A/C NOT FOR ALL
49VUCOM/ACP F/O/BITE/ INT 2 AUDIO/3&5 OCCPNT5RNG07
** ON A/C NOT FOR ALL
49VUCOM/ACP CAPT/SELCAL/INT 1 AUDIO/AVNCS4RNG06
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/ELAC1/NORM/SPLY15CE1B06
49VUFLIGHT CONTROLS/SEC1/NORM/SPLY21CE1B03
** ON A/C ALL
105VUFLIGHT CONTROLS/ELAC2/STBY SPLY16CE2A02
105VUFLT CTL/ELAC1/STBY SPLY16CE1A01
105VUFLT CTL/SEC1/STBY SPLY22CEB01
** ON A/C NOT FOR ALL
121VUAUTO FLT/STICK/LOCK13CAN16
** ON A/C ALL
121VUFLIGHT CONTROLS/SEC3/SPLY21CE3Q19
121VUFLIGHT CONTROLS/SEC2/SPLY21CE2Q18
121VUFLIGHT CONTROLS/ELAC2/NORM/SPLY15CE2R20
** ON A/C NOT FOR ALL
121VUAUTO FLT/STICK/LOCK13CAN18
Subtask 27-92-41-010-089-A ** ON A/C NOT FOR ALL
D. Remove the Cursor Control Device (CCD) (Ref. AMM TASK 31-61-14-000-801).
Subtask 27-92-41-010-058-A ** ON A/C NOT FOR ALL
E. Removal of the cover panel.
F Cover Panel ** ON A/C NOT FOR ALL
   (1) Release the lock (9) and remove the handle (1).
   (2) Remove the screws (4), the screw (6), the screw (8), the washers (5) and the washer (7).
   (3) Release the catches (2) and remove the cover (3).
Subtask 27-92-41-010-058-B ** ON A/C NOT FOR ALL
E. Removal of the cover panel.
F Cover Panel ** ON A/C NOT FOR ALL
   (1) Remove the screws (9) and the handle (1).
   (2) Remove the screws (4), the screw (6), the screw (8), the washers (5) and the washer (7).
   (3) Remove the screws (2) and the cover (3).
Subtask 27-92-41-480-051-A
F. Installation of the Tools
   (1) Put the 98D27903500000 PIN-SIDE STICK LOCKING (93) in position on the side stick assembly.
F Bellows
   (2) Put the WARNING NOTICE(S) on the side stick to tell persons not to operate the side stick.
4. Procedure
Subtask 27-92-41-020-058-A
A. Removal of the Bellows
   (1) Remove the ligature cord (89) that attaches the bellows (90) to the support (92) and discard it. Fold the bellows (90) over the handle (91).
   (2) Remove the ligature cord (89) that attaches the bellows (90) to the handle (91) and discard it. Remove the bellows (90).
   (3) Put a protection in position to make sure that no unwanted materials goes into the side stick opening.
[Rev.10 from 2021] 2026.03.31 23:58:57 UTC
"Aviabrain" 2025