Removal of the Dampers

TASK 27-92-41-000-003-A
Removal of the Dampers

WARNING: MAKE SURE THAT THE SIDE STICK ASSEMBLY STAYS IN THE VERTICAL POSITION DURING THE MAINTENANCE PROCEDURES. IF NOT THERE IS A RISK OF SKYDROL LEAKAGE. SKYDROL CAN CAUSE INJURY AND/OR DAMAGE.

NOTE: This task is not applicable for the new-generation side-stick unit. For the new-generation side-stick unit, refer to the procedure (Ref. AMM TASK 27-92-41-000-802). To know if the side-stick installed on the aircraft is a new-generation side-stick unit, refer to the procedure (Ref. AMM TASK 27-92-41-860-801).

ZONE: 211
ZONE: 212

1. Reason for the Job
Self Explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	STRING - DRAW
98D27303001001	1	HOLDER - SIDE STICK

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
211	COCKPIT
212	COCKPIT

C. Referenced Information

REFERENCE	DESIGNATION
TASK 27-92-41-000-001-A	Removal of the Side Stick Assembly
Dampers

3. Job Set-up
Subtask 27-92-41-010-052-A

A. Remove the side stick assembly (Ref. AMM TASK 27-92-41-000-001).

Subtask 27-92-41-480-053-A

B. Install the side stick assembly on the 98D27303001001 HOLDER - SIDE STICK.

4. Procedure
Subtask 27-92-41-020-052-A

A. Removal of the Side Stick Damper
(1) Cut and discard the cotter pins (50) from the nuts (51).
(2) Remove the nuts (51) and the washers (52).
(3) Remove the bolts (54), the damper (53) and (55) and hold it in the vertical position
(4) Fully compress the damper (53) and (55) and hold it in this position with a STRING - DRAW

[Rev.10 from 2021] 2026.03.31 23:59:04 UTC