Removal of the Proximity-Sensors of the Interconnecting Strut

TASK 27-51-15-000-002-A
Removal of the Proximity-Sensors of the Interconnecting Strut

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

FIN: 37CV
FIN: 38CV
FIN: 39CV
FIN: 40CV

1. Reason for the Job
To give ATA reference to agree with CFDS message.
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY BARRIER(S)
No specific	AR	WARNING NOTICE(S)

B. Referenced Information

REFERENCE	DESIGNATION
TASK 27-51-44-000-002-A	Removal of the Proximity-Sensor of the Interconnecting Strut

3. Job Set-up
Subtask 27-51-15-941-050-A

A. Safety Precautions
(1) Put the SAFETY BARRIER(S) in position.
(2) Put a WARNING NOTICE(S) in position to tell persons not to operate the flight controls.

4. Procedure
Subtask 27-51-15-020-050-A

A. Remove the Proximity Sensor
(1) Remove the applicable proximity sensor (Ref. AMM TASK 27-51-44-000-002).

[Rev.10 from 2021] 2026.03.31 23:52:28 UTC