Removal of the Wireless Access Point (WAP)

TASK 23-36-42-000-801-A
Removal of the Wireless Access Point (WAP)

ZONE: 230
ZONE: 240
ZONE: 250
FIN: 3010MH1 ** ON A/C NOT FOR ALL
FIN: 3010MH2 ** ON A/C NOT FOR ALL
FIN: 3010MH3 ** ON A/C NOT FOR ALL
FIN: 3010MH4 ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	1	STEPLADDER 1.0 M (3.3 FT)
No specific	AR	TIE WRAP(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
230	FWD PASSENGER COMPARTMENT
240	MID PASSENGER COMPARTMENT
250	AFT PASSENGER COMPARTMENT

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 25-23-41-000-001-A	Removal of the Ceiling Panels
Wireless Access Point (WAP) ** ON A/C NOT FOR ALL
Wireless Access Point (WAP) ** ON A/C NOT FOR ALL

3. Job Set-up
Subtask 23-36-42-861-050-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).

Subtask 23-36-42-865-050-A ** ON A/C NOT FOR ALL

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
2000VU	WAP	27MH	D07

Subtask 23-36-42-010-050-A ** ON A/C NOT FOR ALL

C. Get Access
(1) Put a STEPLADDER 1.0 M (3.3 FT) below the related ceiling panels.
(2) Remove the related ceiling panels (Ref. AMM TASK 25-23-41-000-001).

4. Procedure
Subtask 23-36-42-020-050-A ** ON A/C NOT FOR ALL

A. Removal of the Wireless Access Point

Wireless Access Point (WAP) ** ON A/C NOT FOR ALL

(1) Remove and discard the TIE WRAP(S) (14).
(2) Remove the cable (15) from the cable brackets (9).
(3) Disconnect the electrical connectors (7) from the Wireless Access Point (WAP) (1).
(4) Loosen the screws (6) and disconnect the WAP adapter (5) from the receptacle (4).
(5) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(6) Hold the cable brackets (9) and remove the screws (12), (13), the washers (11) and the spacer (10).
(7) Remove the cable brackets (9).
(8) Hold the WAP (1) and remove the screws (2) and the washers (3).
(9) Remove the WAP (1).

[Rev.10 from 2021] 2026.04.02 06:12:11 UTC