Cleaning of the Video Tape Reproducer
TASK 23-36-00-100-002-A
Cleaning of the Video Tape Reproducer
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Referenced Information
3. Job Set-up
Subtask 23-36-00-861-053-A ** ON A/C NOT FOR ALL Subtask 23-36-00-865-077-A ** ON A/C NOT FOR ALL
Subtask 23-36-00-160-051-A ** ON A/C NOT FOR ALL
Subtask 23-36-00-410-056-A ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.04.02 06:12:09 UTC
Cleaning of the Video Tape Reproducer
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | AR | VIDEO - CLEANING TAPE |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 24-41-00-861-002-A | Energize the Aircraft Electrical Circuits from the External Power |
| TASK 24-41-00-861-002-A-01 | Energize the Aircraft Electrical Circuits from the APU |
| TASK 24-41-00-861-002-A-02 | Energize the Aircraft Electrical Circuits from Engine 1(2) |
| TASK 24-41-00-862-002-A | De-energize the Aircraft Electrical Circuits Supplied from the External Power |
| TASK 24-41-00-862-002-A-01 | De-energize the Aircraft Electrical Circuits Supplied from the APU |
| TASK 24-41-00-862-002-A-02 | De-energize the Aircraft Electrical Circuits Supplied from the Engine 1(2) |
Subtask 23-36-00-861-053-A ** ON A/C NOT FOR ALL Subtask 23-36-00-865-077-A ** ON A/C NOT FOR ALL
B. Make sure that this(these) circuit breaker(s) is(are) closed:
Subtask 23-36-00-010-054-A ** ON A/C NOT FOR ALL | PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 2000VU | PES-VIDEO-CABIN-RH AFT | 25MH | C06 |
| 2000VU | PES-VIDEO-CABIN-LH | 23MH | C05 |
| 2000VU | PES-VIDEO-CABIN-RH FWD | 24MH | C04 |
| 2000VU | PES-VIDEO-CABIN-LH FWD | 22MH | C03 |
| 2000VU | PES-VIDEO-CONTROL-VCC | 21MH | C02 |
| 2000VU | PES-VIDEO-CONTROL-MAIN | 20MH | C01 |
C. Open the applicable overhead stowage compartment(s).
Subtask 23-36-00-860-069-A ** ON A/C NOT FOR ALL D. Aircraft Maintenance Configuration
(1) Push the MASTER POWER pushbutton switch from the SCU.
4. Procedure(1) Push the MASTER POWER pushbutton switch from the SCU.
NOTE: Wait for a minimum of 3 minutes after the SCU power-on, then continue with the procedure.
Subtask 23-36-00-160-051-A ** ON A/C NOT FOR ALL
A. Clean the Video Head
(2) Put the VIDEO - CLEANING TAPE into the VTR and push the STOP membrane switch immediately.
(3) Push the PLAY membrane switch.
(4) After 15 seconds push the STOP membrane switch and the EJECT membrane switch.
(5) Remove the cleaning tape from the VTR.
(6) If you have removed a video tape, put it back into the related VTR.
5. Close-upCAUTION:
DO NOT USE A CLEANING TAPE FOR MORE THAN 15 SECONDS. LONGER OPERATION OF THE CLEANING TAPE WILL CAUSE DAMAGE TO THE VIDEO HEAD.
(1) Remove any installed video tape from the Video Tape Reproducer (VTR). (2) Put the VIDEO - CLEANING TAPE into the VTR and push the STOP membrane switch immediately.
(3) Push the PLAY membrane switch.
(4) After 15 seconds push the STOP membrane switch and the EJECT membrane switch.
(5) Remove the cleaning tape from the VTR.
(6) If you have removed a video tape, put it back into the related VTR.
Subtask 23-36-00-410-056-A ** ON A/C NOT FOR ALL
A. Close the applicable overhead stowage compartment(s).
Subtask 23-36-00-860-070-A ** ON A/C NOT FOR ALL B. Put the aircraft back to its initial configuration.
(1) Push the MASTER POWER pushbutton switch from the SCU.
(2) De-energize the aircraft electrical circuits (Ref. AMM TASK 24-41-00-862-002).
(1) Push the MASTER POWER pushbutton switch from the SCU.
(2) De-energize the aircraft electrical circuits (Ref. AMM TASK 24-41-00-862-002).