W DOC AIRBUS | AMM A320F

Removal of the Remote Transducer/Remote Jack Unit (RJU) (Passenger Seats)


TASK 23-33-45-000-001-A
Removal of the Remote Transducer/Remote Jack Unit (RJU) (Passenger Seats)


ZONE: 200
FIN: 604MK ** ON A/C NOT FOR ALL
1. Reason for the Job
Self explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
CAP - BLANKING
No specific
AR
SAFETY CLIP - CIRCUIT BREAKER
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
200
UPPER HALF FUSELAGE
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 24-41-00-861-002-A
Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01
Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02
Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 23-33-00-00-01
PASSENGER ENTERTAINMENT - DESCRIPTION AND OPERATION
TASK 25-21-00-00
PASSENGER COMPARTMENT SEATS - DESCRIPTION AND OPERATION
3. Job Set-up
Subtask 23-33-45-861-050-A ** ON A/C NOT FOR ALL
A. Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).
Subtask 23-33-45-010-050-B ** ON A/C NOT FOR ALL
B. Get Access
   (1) For the location of this component, refer to paragraph Component Location
(Ref. AMM D/O 23-33-00-00).
   (2) If necessary, remove the related cover(s) to get access to the seat component(s) (Ref. AMM D/O 25-21-00-00).
Subtask 23-33-45-865-073-A ** ON A/C NOT FOR ALL
C. Open, safety and tag this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
2000VUPES-MUSIC - CTL21MKD01
** ON A/C NOT FOR ALL
2000VUPES-VIDEO-CONTROL-VCC-DS/C21MHC02
2000VUPES-VIDEO-CONTROL-MAIN20MHC01
2000VUPES-MUSIC-CABIN AFT-LH22MKD04
2000VUPES-MUSIC-CABIN FWD-RH24MKD03
2000VUPES-MUSIC-CABIN FWD-LH23MKD02
** ON A/C NOT FOR ALL
2000VUPES-MUSIC-CTL21MKD01
4. Procedure
Subtask 23-33-45-020-050-R ** ON A/C NOT FOR ALL
A. Removal of the Remote Transducer/Remote Jack Unit
   (1) Carefully release the Remote Transducer/Remote Jack Unit (1).
   (2) Disconnect the electrical connector(s) (2).
   (3) Remove the Remote Transducer/Remote Jack Unit (1).
   (4) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
[Rev.10 from 2021] 2026.04.02 06:12:07 UTC